PRINT INSCTURCTIONS BELOW The gadget seen by 9 people!
This collection not only comes with the "not patented" Doggo Stopper, but also includes the newly released BayBae Stopper!
As a BONUS, I've included the highly anticipated, NOT YET released BOP!! Known by it's internal codename: Block Of Plastic.
These are meant to replace the 2x4s that every one has in thier place of residence, when "the gates" are installed. you know what i'm talking about
Dimensions
Top - 37mm x 4mm Bottom indent - 39mm x 2mm v2 bottom flange diameter - 50mm v3 bottom flange diameter - 60mm Height - 54mm
I hope you all enjoy these state-of-the-art, only found here, Treasures that the world has provided to you.
** PRINT INSTRUCTIONS **
REMEMBER: The use of these will put a lot of stress and pressure on the part. Please consider material type before printing.
Recommended Material: ABS, ABS+, ASA, Nylon, PET-G(Maybe)
Print Settings:
- Printed in 69%
niceinfill. Remember, lots of force. - 4 walls
- 5 Top and Bottom
I didn't use supports for the indent on the bottom. I was able to bridge that area. If you would like to use supports, the area is small. Should not be too much waste or slow to print.
** INSTALLATION INSTRUCTIONS **
I included pictures of the foam sticky pads I used. You know the type, by 3M. By the Command thingys.
Matierials Needed
- Those foam sticky pads I just talked about.
- 38mm x 5.5mm
Remove the 2x4 between your gate of choice and the wall. Place one of the choosen blocks of plastic between the gate and the wall.
Job Complete! Congratulations!
Have fun and print on.
Thanks for stopping by!