Brian H

Planter with Legs - The Ellwood

by
LoftedGoods
Follow
Follow
Remix Model
LoftedGoods
LoftedGoods
|
Image 1 of 9
Planter with Legs - The Ellwood 3d model
LoftedGoods
LoftedGoods
|
Image 1 of 9
Planter with Legs - The Ellwood 3d model
2D
3D
Makes
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model
Planter with Legs - The Ellwood 3d model

Prints with no supports. I recommend using brims for the legs.

3 sizes included — 2.5", 4.5", and 6.5"

The legs need to be glued in to the base. I typically use Weld-On and a syringe to attached the legs but super glue works too!

Supports None needed!

Scaling Can be scaled although the clearances for the legs may be too loose or too tight if you scale too far in either direction.

Orientation The planter should have its bottom on the build plate. The legs should be upright with with tenon (peg) facing up. Use a brim for the legs.

Print Settings .2mm layer height 15% grid infill 2 walls

Filament & Hardware Filament: Bambu Lab Matte Latte Brown PLA & Bambu Lab Marble PLA

Filament and non 3D printed items for this model can be found on my Amazon Storefront, linked here: https://linktr.ee/loftedgoods


116 Likes1.1K DownloadsAugust 31, 2023


116 Likes1.1K DownloadsAugust 31, 2023