Vileplume Pokemon Night Light (MULTIPART).stl

G'day everyone, First of all, a big thanks to Polymaker because of them this awesome Vileplume night light is FREE! I absolutely love getting the opportunity to show off their awesome range of filaments, I used the following.....

Polylite PLA Silk Rose - For the flower. Polyterra Matte Electric Indigo - For Vileplumes body. (please note that these names may change with the introduction of their exciting new "Panchroma" range).

The LED puck/disc is a cheap $4 AUD LED light that I bought off of AliExpress. I'm sure you could find the same or similar on many other sites. The LED is roughly 40mm in diameter, if yours is bigger you can always just sale up the entire print to make yours fit. You will most likely need to resolder the wires back into the LED light once you have ran them through the main body (dependent on your model of LED light). Below is a small video showing the simple build process. As always, this is a multipart design so everyone can make it, with all parts being pre-scaled for a tight but easy fit.

I'm happy to answer any questions you may have : )

Cheers,