Serve up all kinds of treats in a fun way with this superb treat dispenser that can be upgraded and modified as you like!
One dispenser, infinite possibilities!
Print out the parts of the common base, and choose the module you wish to install in the central part of your dispenser from those available.
But nothing is definitive. You can change your module at any time, in just a few seconds!
Do you have several types of treats that you'd like to use with a single dispenser? Print multiple tanks and close the ones you're not using with the tank cover.
3D printing settings
Some files need to be printed more than once. If the file name has an "x3" at the end, this means you need to print it in 3 copies.
For module 2, you'll need a sheet of translucent plastic (report cover, cut smooth bottle) measuring 89x129mm.
-Tank-
Reservoir cap / Reservoir cover / Reservoir 1:
Print flat in the original direction, without supports. It is advisable to use a translucent filament for better rendering and to see the treats from outside the dispenser.
-Common base-
Distributor base / Screw handle / Lower part / Upper part :
Print flat in the original direction. It's not necessary to use supports, but if your printer has trouble printing the cantilever, you can activate supports.
Pillars x3 / Worm gear :
Print in the original direction. Brackets are required to support the pillar legs, and the worm screw start. Secure the brackets to the threaded parts. You can activate a border if your grip on the platen is not optimal.
-Module 1 Slide-
Slide part 1 / Slide part 2 :
Print in the original direction, without supports. If your printer has difficulty printing the overhang, supports may be necessary (lock the supports on the threaded part).
Full slide :
Print in original direction. Activate brackets to support the lower part of the slide only. No support required on the threaded part.
-Module 2 Slides-
Drop system / Left guide x2 / Right guide x2 / Chevron x2 / Candy guide :
Print in original direction, without supports.
High drop system:
Print in the original direction, activating the supports.