This time, I finally challenged the tank. Yes, it is a foldable tank. The first selected model was the German Tiger-1 late model, well known in World War II.
Since almost every detail has been expressed, just looking at it will give you great pleasure. As with other designs, this design has a lot of moving parts, especially wheels, so it is necessary to adjust the height of the nozzle well so that the gaps do not stick when printing the first layer. In particular, the most important thing to note when printing this design is to print the Track / caterpillar. Pay attention to the print of the first layer so that the Track / caterpillars do not stick together.
The process of folding this design is as follows.
- Fold the front part first. Since the living hinge is used, fold it carefully and slowly so as not to break it.
- Insert the side part with wheels on the front part and the top part. Check and fit each protrusion and hole.
- Insert the rest of the side part. The body has been completed.
- Connect the two tracks / caterpillars first.
- Wind the track / caterpillar around the wheel. There is a change in shape, and the non-simple side is the outside of the track / caterpillar.
- Fit the start and end parts of the track / caterpillar.
- Put the cannon on the turret.
- Glue the small parts on the back.
※ If the track is loose, try the following method.
- If you increase the material flow in all slicers, more material will be discharged and the volume of the part will increase. This effect reduces the gap between the parts so that the tracks do not come loose or fall out.
- And in case of using additional Cura, use Outer wall inset or Skin overlap percentage option.
1 : 48 scale When expanded, size = X 134mm, Y 178mm, Z 112mm After folding X 82mm, Y 185mm, Z 62mm
Design by GOODesign