2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsTree
Shelf designed to store/display media. These shelves were derived from the original set, however are sized to store DVD form-factor cases. Mount them with a screw or pushpin through the back. Alternatively, double sided tape can be laid into the recesses on the back, but my luck with that method has been spotty at best.
Categories:
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density15 %
SupportsTree