Shelves designed to store/display media.  Mount them with a screw or pushpin through the back.  Alternatively, double sided tape can be laid into the recesses on the back, but my luck with that method has been spotty at best.  Printing these vertically takes longer, but the mating surfaces on the connection point end up much cleaner.  Horizontal printing is faster, but they put up more of a fight to put together.

Modular Media Shelving

(CD) 000007 - 01 Endcap Right.step

Revision/expansion of my original hurricane fender design.  This iteration utilizes a two piece design to hopefully mitigate cracking caused by excessive flexing, as well as including fenders with mounting points for both S-lock(shredlights), and picatinny attachments (picatinny rail modeled from drawing dimensions. I cannot personally test correct fitment as I don't own any pic stuff).  Glue your chosen fender design to its respective backing plate, and slot on the alignment clip to keep the pieces aligned while the glue sets.  Use clamps at your discretion.  Slot the assembly onto your boards hangar, and use a fender washer to hold the fender against the end of the hangar BEFORE replacing your wheel washer.  At this point, tighten a hose clamp onto the hex bore inside of the fender to reduce forward/backward slop.  If using the picatinny fender, glue and slot the rail onto its dovetail joint.(Once more, I haven't personally tested picatinny fitment)  These were mainly tested with BKB 6inch AT wheels, however I believe these will also work with Meepo Cyclones.

Meepo Hurricane Fenders V.2

000015 - 01 Right Fender.step

Replacement rubber grip for the Klein impact 11 in 1 screwdriver. This is not a 1 to 1 recreation, however it roughly follows the design of the original grip.

Printed on a Bambu X1C with Matterhackers translucent purple TPU

Use supports
3 wall layers
20% gyroid infill

Klein Grip.stl

UPDATE 9/29/24: As my modeling workflow has improved, I've become increasingly dissatisfied with this model as it presently stands.  As a result, I've remodeled this project from the ground up to make future modifications easier on my end.  While this model page will remain up for legacy purposes, I'd HIGHLY recommend anyone new to this project instead use the following link, where all future updates/variations will be posted. (https://thangs.com/designer/Furr/3d-model/Meepo%20Hurricane%20Fenders%20V.2-1147789?source=All+Files)

Splashguard/fenders for use with the Meepo Hurricane in conjunction with Meepo's Cyclone racing wheels. Printing Details in the attached readme.

V5 - Redrafted the model from scratch to allow for a two part glue together design

V4 - Increased fender profile radius to reduce rubbing issue on bumps

V3 - Fixed 5mm variation between left and right fender

v2 - Oopsie I accidentally created a BS revision, and I don't know how to remove it

Furr

Achievements

Seedling

Modular Media Shelving

Meepo Hurricane Fenders V.2

Klein Grip.stl

Meepo Hurricane Fenders (LEGACY)