This is a LED lit Star Wars themed shadow box with 3 panels, a diffuser, the chamber, and a lid adorned with the Tie Fighter. The view is through the window of a Tie Fighter blasting a X-Wing with the destroyed Death Star in the background.
The panels and diffuser will need to printed with transparent PLA up to the panel graphic where you will need to do a filament change with the exception of the diffuser being transparent only. Any LED will work and I recommend a multi-color LED strip with a radio frequency controller preferred (Infrared will work with reduced range). Panels go in order from front of chamber (window end) alphabetically. The blaster beams should be closest to the window followed by the X-Wing, Death Star, and then diffuser. There is a 5mm hole in the back for the USB cable to come through and will need to be soldiered with heat shrink tubes applied. The emblems can be hot glued to the chamber and held gently wit a clamp until set.
MAY THE FORCE BE WITH YOU!
Be sure to insert the panels carefully, feed them in gently.3D printing settings
Resolution: 0.2mm Infill: 13% Gyroid Supports to build plate only: Lid and chamber models. Print the chamber and lid right side up.