Greninja Shuriken Spinner Mini - Pokemon
byDice3D DesignsThis model is restricted by licensing terms.
View license.
Introducing the 4-Point Shuriken famously used by Greninja in Pokemon but as a small fidget spinner! It is print in place with no supports but you may need to use a brim or adhesive on your bed because of the bearings. I don't use either though I have a Sliceworx flex dipped plate (works amazing for adhesion). This version is about the size of an adult's palm and the center ring can fit half your finger through at 100% scale.
Categories:
8 Likes29 DownloadsNovember 10, 2024
8 Likes29 DownloadsNovember 10, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament • 0.2mm
MaterialPLA
Layer height0.2 mm
Infill density10 %
SupportsNone
BrimYes