ORIGAMI PIP | Table Lamp E14, E26, E27 print-in-place

(NOTE: this version is available at no extra-cost to those who already purchased the tripod-mounted Origami lamp)

A brand new twist on the ORIGAMI table lamp. This version is 100% print-in-place and 100% free-standing. No need for a base/stand.

Just mount your E14 or E26 or E27 bulb sockets directly where the shade's inner shell narrows into a mounting neck in the middle.

2 sizes available:

• the original Large version (height 250mm)
• and a Small version (height 209mm) to accomodate smaller printers.

Both sizes work with either E14, E26 or E27 sockets. The middle opening fits the E26 / E27. For E14, just print 2 adapter discs (STL provided) , and place them above and below the narrow neck inside the shade.

You can get the power cords from Amazon here:
 For Europe: E27 cord:  https://amzn.to/3OVrZjK
 E14 cord:  https://amzn.to/3TchBqs

For the US: E26/E27 cord:  https://amzn.to/3U0Xyvy

Happy printing!

DIMENSIONS (Large) | Ø200 mm x H 250 mm

DIMENSIONS (Small) | Ø168 mm x H 209 mm

3D PRINT SETTINGS

The shade prints upside-down (STL files already oriented properly).

The shade prints in standard mode, not vase mode. No supports required. No infill required.

Wall line count: 2 top layers: 2 Bottom layers: 3 Resolution: 0.2 or 0.3mm or less Build adhesion type: Brim 4 to 6mm Supports: None Infill: None (0%)

The shade on the pictures was printed with some “fuzzy skin”.

• fuzzy skin thickness: 0.25mm
• fuzzy skin point distance: 0.8mm