O' RIDGE | Floor lamp E27
Give your space a modern mid-century vibe with this fast-print O' RIDGE floor lamp!
It is the big brother of the DELTA RIDGE Table Lamp.
The shade and base are each made of two thin shells that join at the top and bottom, casting a warm & soft - but still very bright - glow. They both print very fast with the right settings listed below. The shade takes about 3.5h, and the stand less than 2.5h.
The hole at the center of the fastening bracket is for a standard E27 socket screw. Hole diameter: Ø41mm
Happy printing!
DIMENSIONS | Ø250 mm x H 180 mm
PRINTING | Shade ~3.5h | Stand ~2.5h
Bulbe socket | E27
3D PRINTING SETTINGS For the print to be fast enough and the shade transparent enough, refer to the settings guidelines below.
SHADE: The shade prints in standard mode, not vase mode, but it needs some particular settings so the shell stays empty and the wall thickness is the same all over. Wall line count: 2 (no more!) Top layers: 2 (and only 2! or else you will get accidental extra wall lines here and there) Bottom layers: 3 Resolution: 0.2mm Build adhesion type: None Supports: None Infill: None (0%)
BASE/STAND: The base must be printed upside-down, so with the round face for the E27 socket flat on the printing bed. Need some infill just in the mounting bracket and nowhere else. Infill: 40% Infill Support: On (go to avanced settings to activate it) Infill Overhang Angle: 80% (so you will "only" have infills inside the middle bracket, but not in the rest of the volume) Wall line count: 2 (no need for more) Top layers: 2 (and only 2! or else you will get accidental extra wall lines here and there) Bottom layers: 4 Resolution: 0.2mm Build adhesion type: None Supports: None