Fibonacci Fearherboard

204 downloads · 4 years ago · Bear in mind this is designed as a safety feature and I take no responsibility for its use. I print

Description

Bear in mind this is designed as a safety feature and I take no responsibility for its use.

I printed it with PETG at 3mm height (for speed reasons only), wall strength 3, 3 top & bottom layers, 12% gyro infill. Works like a charm. You can put something sticky (rubber tape) at the bottom to give it more grip. The thumbscrew simply needs a "halt at height" to insert a standard M8 nut. A M8 coach bolt perfectly fit in the railing of my table saw. All it needed was a little plastic washer to stop it from spinning. You may have to adapt the design to fit your machine.

If you like what you see you can tip me on paypal.me/CaptainKonzept

Happy Printing

Tags:

Discussions

Xerkies3 years ago

During the halt print part of the thumb screw. The layer after the print wasn't adhering to anything. So I went to add a overhang to make the roof printable. This is my first time on this site. Is there a way I can post a revision of this? I'd like to post it on Thingiverse if you don't mind. I'll definitely credit you. :)