Bowden Tube Holder for K1

This is a press fit bowden tube holder for the Creality K1. If you connect a dry box or just want to guide the filament using a bowden tube, this will hold the tube in place.

Tolerances are important for it to press fit into the honeycomb.

Note - Print it vertical for maximum strength. No supports needed for printing but if you feel just add a brim for adhesion.

Recommended Print settings

• Material - PLA
• Supports - None
• Layer height - 0.2mm
• Infill - 15%
• Bottom layers - 4 or more

Please support me at Paypal or Buymeacoffee for more free models :)