Yuari, baby magical dragon, articulated

Please read pdf for full instruction.

This dragon is very easy to print. In my opinion best size is 120%. I printed with bambulab at a high quality setting and a 0.16 layer. I use the brim for safety, but in the large version it may not be necessary. Good calibration and retraction is necessary for a great result.

For personal use only All my files are protected by Copyright, should NEVER be shared, resold or remixed. To legally sell physical print of my design visit: www.bottega3d.com or subscribe a commercial level

Settings: NOZZLE: 0,4 mm. LAYER: 0.16 – 0.20 OUTER WALLS: 3 INFILL: 10% SUPPORTS: NO Z-HOP: 0.8 BRIM: If necessary