Another clockface to share Free for a limited time and then will Join the members welcome stash. This one is a Halloween treat and is of Doctor Frankenstein's Monster at the center. An 8mm hole has been added in the 3mf file but the STL is solid. Enjoy this one for seasonal fun (and yes, a few numbers are not quite straight. That is on purpose as it makes the whole clockface a little unsettling to look at).
For this Model:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 225x225mm in size
You may print at higher layer heights below the Min Depth of 0.32mm
The Max Depth is 2.2mm and the Actual Depth is 2.3mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Matte Ivory White Transmission Distance: 3.5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Blue Gray
At layer #12 (1.04mm) swap to Beige
At layer #18 (1.52mm) swap to Ivory White for the rest.
