Celebration of the Day of the Dead - Dressing the Part Set of Bookmarks

Week 14 is starting off with a celebration of death. A set of bookmarks around the topic of the day of the dead.

For these models:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 66.9x200mm in size You may print at higher layer heights below the Min Depth of 0.4mm The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.6 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments

Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Blue Gray At layer #12 (1.04mm) swap to Orange At layer #15 (1.28mm) swap to Jade White for the rest.