Week7 - After the popularity of a prior set of bookmarks on Makerworld, I created these to complement. The dragon guards the doors in these celtic knot designs.
For these Models:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 65.03x205mm in size
You may print at higher layer heights below the Min Depth of 0.32mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm
Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA BambuLab Basic Brown Transmission Distance: 2
PLA BambuLab Basic Beige Transmission Distance: 8
PLA PolyLite White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Brown
At layer #10 (0.88mm) swap to Beige
At layer #18 (1.52mm) swap to White for the rest.
