Voron 2.4 ADXL Storage Case (LDO Kit Rev C)

Provides storage for the ADXL PCB/mount, screws and FFC ribbon cable that comes standard with LDO Rev C kits. May fit other kits and configurations, no guarantees. Allows for FFC cable to remain attached to the RPI. Eliminates the need to roll the printer over to access the electronics bay every time input shaper calibration is run.

Fits Voron 2.4 350, and may fit others.

Print using Voron guidelines as stated in build guide/assembly manual.

Recommend strain relief for the FFC cable at the RPI (cable tie to existing cable near RPI or by other means). I tied to the USB cable at the RPI.

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License. http://creativecommons.org/licenses/by-nc-sa/4.0/