Tray Inserts for Dungeon Master Tome - Dungeons and Dragons

The inserts provided here are sized for the Dungeon Master Tome I designed.

Feel free to remix your own inserts to fit my tome.

The dimensions specified in each insert is in "units". Each unit is 30.5x30.5x25.2mm (Not including tolerances).

So if I wanted to make an insert that is 3x5x2, then, incorporating a 0.2mm tolerance on each side, the dimensions would be: (((30.5 * 3) - 0.4) by ((30.5 * 5) - 0.4) by ((25.2 * 2) - 0.4))mm

The "Cut" inserts were designed to fit on the top row of the tome. Because of the way the tome closes, clearance had to be made for the lid. So if you know your insert is going to be at the far end of the tome, you'll want to add a similar cut.

The dimensions of my cuts are 13.4mm from the edge and the angle is at a 45 degree angle.

There should be no problem scaling these if you find the fitment to be a little tight.