This pumpkin was designed using codeblocks to create an almost skeletal, spiralling look.
It can be printed with no supports - in fact I'd recommend that as supports would be really difficult to remove!
I've test printed this at 75% 100% and 150% and tried it in PLA and PETG and had successful prints every time so far but feedback is always appreciated if you do find any issues!
There are 3 files:
- Pumpkin with stalk is all in one piece and can be printed in one colour or with a colour change for the stalk.
- The other two are the pumpkin and stalk separately, the stalk should fit well without glue but it might depend on your printer/settings a little!
Categories:
61 Likes433 DownloadsSeptember 24, 2021
61 Likes433 DownloadsSeptember 24, 2021