This model was created to hold 5- Close to My Heart Ink-pads per printed section. The model is stackable with magnet holes for 6mmX2mm magnets (https://amzn.to/3KJDv0k). To provide some stability and link the holder sections and top and bottom sections together. Disclaimer: The strength of the magnets are not enough lift the unit by the handle. Although I am theorizing a clip system to hold the hold the top and bottom and sections together for transport. if any one has any thoughts please share.
The Heart handle was glued to the top after printing to avoid the hassle of supports. Each holder section can be printed support-less with it on its back and printing the slot upward.
I also printed a thrust bearing from this model by Alien_Loaf. https://www.thingiverse.com/thing:4327675. added some 6mm Airsoft BB's https://amzn.to/3EOQJ8p and Glued to the bottom base and glued some Duck Brand Shelf Liner [https://amzn.to/3kLlkwu for some grip.
This allowed the holder to turn if you choose to stack the pad holder in a front to back orientation.