This is a flash hider of my own design combining elements from various popular flash hiders found in popular video games. Would it work IRL??? Probably not!!!
This has a 14mm CCW thread that allows fitting to airsoft replicas ONLY!!! Any attempts to fit this flash hider replica to anything other than airsoft replicas will likely result in injury!!!
Along with the main flash hider there are shim files to allow you to "time" or align to your barrel in the correct orientation, use 1 or several of these in combination to get the best fit. A rubber O-Ring would also suffice.
Please note that none of my flash hider files are 100% accurate in any way and are my interpretation of pre-existing designs.
I have more designs available over at https://cults3d.com/en/users/AirsoftProtoTech/3d-models
3D PRINTING SETTINGS Material: PLA+ or Stronger however PLA is more than sufficient
Recommended to print vertically with Tree supports on the large openings.
4 Walls with at least 50% infill
I recommend using adaptive layer height if you can otherwise the finest that your printer can handle.
This file has not been tested however if threads seem tight I would recommend the use of a 14mm CCW tap to open them out.