3D Printing World

Pokebox Switch DS 3DS Game Case

by
3dprintingworld
Follow
Follow
Remix Model
3dprintingworld
3dprintingworld
|
Image 1 of 2
Pokebox Switch DS 3DS Game Case 3d model
3dprintingworld
3dprintingworld
|
Image 1 of 2
Pokebox Switch DS 3DS Game Case 3d model
2D
3D
Makes
Pokebox Switch DS 3DS Game Case 3d model
Pokebox Switch DS 3DS Game Case 3d model
This model is restricted by licensing terms. 

This Pokeball styled game cased has a hinged top with latch and a release button to open it.

It has a hinged top and spring loaded latch so you don’t have to worry about it opening and losing your games. The Switch box will hold 10 games and 6 mirco SD cards. The 3DS and DS version will hold 10 games. Both versions use all the same parts with the exception of the bottom, which is different for each version.

All the parts can be printed without supports with the exception of the button which requires just a little bit of support. After printing the required parts put the ring and the button in between the top and the bottom loops with a .5" long pen spring behind the button and glue the rings together. Then glue the loop assembly onto to the base. There are alignment guides so it can only be glued in the correct orientation Attach the hinge on the lid to the hinge on the top loop using some 1.75mm diameter filament and glue the filament in place on both ends.

This is my go to filament when it comes to red, white, and black. It’s really cheap but I buy a lot of it and have never had a single quality issue and I think it looks great! Solutech White: https://amzn.to/2TL9JLF Inland Black: https://amzn.to/2Bz1hrR Inland Red: https://amzn.to/2ByrOWk Amazon Affiliate link: https://amzn.to/2D76JU0


78 Likes367 DownloadsOctober 10, 2021


78 Likes367 DownloadsOctober 10, 2021
This model is restricted by licensing terms.