Extra service "Flexi Whale Shark Mark-Ⅱ" released!! https://than.gs/m/1154952 If purchased, commercial use license and 3mf files are available.
This is Flexi Whale Shark. In addition to the reproduction of the characteristic back ridges, mix of features not found in the original species, such as the large ridges connected to the dorsal fin like a tiger shark and the tail fin in the shape of a common shark, have been reproduced. Joints are structured to move flexibly, and the mouth is also structured to open and close. It can also keep its mouth closed when placed on flat floor. Please try to find your favorite pose.
Print in Place with no supports. No assembly required. Please take pictures of your Flexi and share them with us!
💰Commercial Use💰 This model is not available for commercial use under "CC BY-NC-ND 4.0" below. Therefore, I am selling the upgraded model with additional detailing and a license for commercial use. If you want to sell my model commercially, please check my Thangs, Cults, and Etsy. https://thangs.com/designer/3dflexseeds/paid-3d-models https://cults3d.com/en/design-collections/3dflexseeds/commercial-use-ver https://flexseedsshop.etsy.com
⚠Warning⚠ Be careful in environments with young children and pets! This model contains small parts. If not properly stored in an environment with young children or pets, it may lead to accidents such as accidental ingestion or injury. If infants or pets are present, please take appropriate measures depending on the situation, such as refraining from 3D printing or storing in an appropriate place.
Do not apply strong force! Applying strong force to a 3D printed model or throwing it may damage the model and lead to accidents such as injuries. In addition, debris from damage to the model may be accidentally ingested by infants or pets. If the model is damaged, dispose of it immediately.
Store them in an appropriate place. After 3D printing, store the model in an appropriate place out of reach of young children and pets. Proper adherence to the precautions will ensure safe use of the model.
🖨Print Setting🧵 Rafts: No Supports: No Build Plate Adhesion Type: Skirt or None Layer Height: 0.1-0.3mm Infill:15-20% Filament material: PLA
{Recommend} Layer Height: 0.2mm Print Speed: 60mm/s Outer Wall Speed: 10mm/s Z Seam Alignment: User Specified Z Seam Position: Right Z Seam Corner Preference: Hide Seam
{Recommend: Bambu Lab Printer} Layer Height: 0.2mm Seam Position: Aligned Wall Loops: 3 First layer: 30mm/s Outer wall: 30mm/s Prime Tower Width: 10mm Prime Volume: 10mm^3 Prime Tower Brim Width: 0mm