These are the door/door wall surround pieces for the magnetic tile haunted house.
PLA Filament works great Layer height 0.2mm Infill 15% Brims recommended for front door wall and french door wall to prevent warping on the corners Neodymium magnets needed: 20x5x2, 10x5x2 and 3x5 Magnetic build plate highly recommended but not absolutely necessary.
Here is a link to Amazon for the magnets needed for these pieces: https://www.amazon.com/shop/3dpmom
3D Print Settings
For the wall pieces, you will need 20x5x2 and 10x5x2 neodymium magnets to be inserted around the edges. I strongly recommend using these size magnets. If you go larger it may not allow the magnets to rotate within their chambers.
I like to alternate these two size magnets between the magnet holes (20x5x2, 10x5x2, 20x5x2, 10x5x2, etc.). I found if I used all 20x5x2 they were too strong and if I used all 10x5x2 it felt a little too weak.I recommend 20x5x2 neodymium magnets to be used for the door pieces.
For the 150x150 Large Front Door Wall and 150x150 French Door Wall pieces there is a small circular space for one magnet centered above each arch. Insert a 3x5 neodymium sized magnet into that space.
For the doors, I recommend 20x5x2 neodymium magnets.
For all of these pieces, add a pause print to insert the magnets as shown in the photos for each design. When the print is paused insert the magnets. After the magnets are inserted, resume the print. That's it:)
I have also included a 3mf print profile with the following print plates: Print Plate #1 (Front Door Wall): one color, pause inserted at layer 30 (layer height 6.0mm), brim added Print Plate #2 (Front Door): one color, pause inserted at layer 30 (layer height 6.0mm) Print Plate #3 (French Door Wall): one color, pause inserted at layer 30 (layer height 6.0mm), brim added Print Plate #4 (L& R French Doors): one color, pause inserted at layer 30 (layer height 6.0mm)
Have fun printing!