Hi folks!
So like I wrote last week, the first version I uploaded was an "early access" and I mentioned I might change some things - And I did!
The first version, while looking nice just didn't work that well in terms of actually holding the sponges, and with bigger/smaller sponges you'd need to start changing sizes or print different versions - I didn't like that, I wanted one that will fit all. Secondly I wanted to also make a Cutlery drainer and with the rounded edges of the initial version it just wouldn't work.
So this one also includes a Cutlery Drainer with compartments to hold the Cutlery steady. It is a little bigger than the sponge drainer.
So this is the updated version with the following changes:
The pocket is now square(ish) and can really hold tightly and firmly any sponge you throw at it! The size is fixed at approx. 7.5 cm width and depth for the sponge area. It can even fit 2 slim ones. Although bigger and sturdier - It uses less material to print. Tail has a steeper anger for better draining Supports - Place supports only on the tail section and the bottom of the drainer.