tracking pixel
S

Snap Close Connector remix

by
Scrath
Follow
Follow
Remix Model
S
Scrath
|
Image 1 of 3
Snap Close Connector remix 3d model
S
Scrath
|
Image 1 of 3
Snap Close Connector remix 3d model
2D
3D
Makes
Snap Close Connector remix 3d model
Snap Close Connector remix 3d model
Snap Close Connector remix 3d model

Remix of this model by electrosync

Assembly: For assembly instructions please refer to his [video(https://www.youtube.com/watch?v=5h5bShThIvw). The assembly is exactly the same as in the original except for the usage of nuts.

Printing: Print 1 of each part except for the clamp where you will need 2. The shell parts require supports for the bolt and nut cutouts

Parts:

  • 3x M3x14 (hex) bolts. M3x12 should theoretically work too but in my case it didn't fit properly and caused problems with the snapping mechanism due to sqashing the two shell halves together slightly
  • 3x M3 nuts
  • 3x M3 washers
  • 1 50mm paperclip

Changes:

  • added cutouts to accomodate sinking the nuts and bolts into the shell
  • added plastic standoffs in the front to prevent overtightening the bolts
  • added access cutout to allow for bending the spring for retensioning without disassembly

72 Likes368 DownloadsNovember 1, 2021


72 Likes368 DownloadsNovember 1, 2021