Remix of [this](https://thangs.com/electrosync/Snap-Close-Connector-31845) model by electrosync

**Assembly:**
For assembly instructions please refer to his [video(https://www.youtube.com/watch?v=5h5bShThIvw). The assembly is exactly the same as in the original except for the usage of nuts.

**Printing:**
Print 1 of each part except for the clamp where you will need 2.
The shell parts require supports for the bolt and nut cutouts

**Parts:**
- 3x M3x14 (hex) bolts. M3x12 should theoretically work too but in my case it didn't fit properly and caused problems with the snapping mechanism due to sqashing the two shell halves together slightly
- 3x M3 nuts
- 3x M3 washers
- 1 50mm paperclip

**Changes:**
- added cutouts to accomodate sinking the nuts and bolts into the shell
- added plastic standoffs in the front to prevent overtightening the bolts
- added access cutout to allow for bending the spring for retensioning without disassembly

Snap Close Connector remix

Snap Close Connector Remix v4.stl

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

Scrath

Snap Close Connector remix