Eggs for your wall! These cute little photo holders can be used to mount your favorite photos.

It is a set of 3 different 3d scanned eggs. The parts are numbered so you always know which white belongs to which yellow. The parts are flattened out where the photos go so you don’t end up damaging them.

Instructions

• Print all parts
• Insert 10x2 mm magnets, pay attention to the direction. Use glue to hold them in place.
• Mount the things on your wall with either wall mount tape a nail or a screw. There is a keyhole cut-out in the back.
• Place your favorite photos!

Print settings Material usage: 40 g per egg

Material: PLA Print direction: files are rotated correctly Support: none Nozzle size: 0,4 mm Line width: 0,4 mm Layer height 0,2 mm Infill: 15% Build plate adhesion type: none