Upload for Search
Search By Text
Upload for Search
Search By Text
Avel

CR-6 se Push-in V-slot Covers (minimalist)

by

triumphinglosersbusiness

Follow
Follow
Like
CR-6 se Push-in V-slot Covers (minimalist) by triumphinglosersbusiness full viewable 3d model
Loading preview...
0 Likes1 DownloadsApril 16, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

0 Likes1 DownloadsApril 16, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4612479. There aren't nearly as many places to put these covers on the CR-6 se as there is for the Ender 3, but at least it's something. I titled the files by where they should go, so it should be pretty self-explanatory. *If you want the front and rear of the middle section to be covered, print the middle set twice. *If your spool holder is clipped on the rear side, print the middle set three times, as one set can just go to front left. **You'll only need one of the rear pieces if your spool holder is clipped back there (BackSingle).




0 Likes1 DownloadsApril 16, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

0 Likes1 DownloadsApril 16, 2022

Community Uploads

No photos added yet, be the first to upload a photo!