A stubby alligator that prints well down to approximately 6.6 cm in length (65% scale). This little guy is super cute in your hand when you print him that tiny. Prints in place with no supports.
Files included:
- unibody STL (single part printing)
- unibody 3MF (single part multicolor printing)
- multipart STLs (separate part printing and assembly)
- multipart 3MF (multicolor separate part printing and assembly)
Print settings and recommendations:
- 3 walls at 0.4mm nozzle size
- 40-60mm/s outer wall speed recommended
- 15% infill (adaptive cubic, cross hatch, or gyroid)
- no supports, slow down for overhangs enabled
- no brim unless adhesion issues arise
- PEZ / polyurea plate highly recommended
- 65% scale tested for all models
Licensing: These model files are for your personal use only. Commercial licensing is available to sell physical prints of all tinymakery designs at patreon.com/tinymakery.
Categories:
2 Likes0 DownloadsSeptember 25, 2024
This model is restricted by licensing terms.
View license.
2 Likes0 DownloadsSeptember 25, 2024
This model is restricted by licensing terms.
View license.