little fox — articulated flexi print-in-place fidget animal

This one lies around and also sits up on front paws just like the cat! Eyes and ears are parted out for multipart printing. The full fox fur coloring will do best with a multicolor printer setup. Prints in place with no supports.

Please consider supporting my work with a Thangs membership. Memberships include commercial licensing to sell physical prints of all tinymakery designs.

Files included:

• unibody STL (single part printing)
• unibody 3MF (single part multicolor printing)
• multipart STLs (separate part printing and assembly)
• multipart 3MF (multicolor separate part printing and assembly)

Print settings and recommendations:

• 3 walls at 0.4mm nozzle size
• 40-60mm/s outer wall speed recommended
• 15% infill (adaptive cubic, cross hatch, or gyroid)
• no supports, slow down for overhangs enabled
• no brim unless encountering adhesion issues
• PEZ / polyurea plate recommended
• 80% scale tested

Licensing: These model files are for your personal use only. Holding an active Thangs membership status grants you commercial licensing to sell physical prints made with these model files. Files are not to be shared or resold. Modifications may only be made for personal and non-commercial reasons.