2D3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament
MaterialPETG
Alpha version of a bubbleponic feeder for a top-feeding deep water culture hydroponic system.
This project will be evolving over time. Current iteration fits a 6" net cup.
Note: This version is design to fit into a reservoir lid, and then have the net cup dropped into it. It uses a lot of material, and the print time is very long (5.5 hrs in PETG on an AnkerMake M5), so this will likely change very soon.
Categories:
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
0 Likes0 DownloadsSeptember 9, 2024
This model is restricted by licensing terms.
View license.
Instructions
Filament
MaterialPETG