This is a standalone Qidi Plus 4 Excess Chute (poop chute). Very simple but works wonders. The base is hollow so you can optionally glue a magnet to keep the chute in place.

Print tips:

• Optional - Since the chute is located next to the exhaust fans, I prefer ABS based materials to PLA or PETG, but I doubt the temperature reaches something that would affect PLA/PETG. I opted for ABS-GF, which is my go to filament for just about anything because of its strength and low warping.

• Optional - I recommend a brim of 5mm since the model is large.

• No supports needed - I chamfered any angle that would otherwise require supports.

• Print at any resolution really, I recommend 0.2+. There is no reason to print this with resolution below 0.2.