Halloween Keychain Tree *Personal use*
I needed a place to hang all my keychains for spooky season and at the same time I wanted it to give off a cozy feeling. So I created this halloween keychain tree with at hollow base where you can place an electric tealight inside. The tree itself prints flat on its back, and then its put on the bowl that can also hold a lot of stuff. This one can also be used for candy or for jewelery to display it.
It has been testprinted down to 60%
Keychains on the photos are not a part of this model, when you buy it you only get the tree for keychains and the bowl.
Important when downloading the design:
This is my design and copyright to sassiecat3d, it's not to be used commercially or resold/remixed without my permission.
The STL/3mf files are under the same clause, not to be re-sold/remixed or use commercially without my permission.
You are welcome to contact me if you would like to know more on sassiecat3d@gmail.com
You agree to these terms when you download this file.
3D PRINTING SETTINGS: I used a .4mm nozzle, .2mm layer height, I use 5% infill. Make sure your printer is all set with a good calibration and retraction before printing it.