Sassiecat3d

Coral Stand and Lamp *Commercial Version*

by
sassiecat3d
Follow
Follow
Remix Model
sassiecat3d
sassiecat3d
|
Image 1 of 10
Coral Stand and Lamp *Commercial Version* 3d model
sassiecat3d
sassiecat3d
|
Image 1 of 10
Coral Stand and Lamp *Commercial Version* 3d model
2D
3D
Makes
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
Coral Stand and Lamp *Commercial Version* 3d model
This model is restricted by licensing terms. 

Important when buying this design version: This is the commercial version of "Coral Stand and Lamp". If you buy it, you will be able to 3D print and sell the prints, as many times as you want to. (Only the physical models, not the digital models/stls file!) This file is not to be sold, shared, remixed, or given to anyone else.

Make sure to use/show my autorised sellers badge when selling my models at events, on websites ect :-)

These files are not made for big companys to make in batches. If you are a company that wants to buy the right to mass produce my models, you may contact me so we can discuss this further.


I wanted to add an underwater themed stand to my dragons and I was inspired to make this after I created the pearl wisp dragon. Then the inspiration hit to also make it a cool etherial lamp with the pearl to light it up from the inside.

The Lamp part can be made in 2 ways. Either by printing the pearl that I made with it and putting LED lights inside it, or by buying a moon lamp and using it to display it on.

My daughter had the moon lamp in her room, and it fit this stand perfectly, with room for the wires inside.

The Pearl is printed in silk filament, and the light gets thru really nicely, even with 3 walls. I put 2 diffrent versions in the folder, one with thicker walls so the light is more diffuse, and one with thin walls, which is the one I printed here.


3D PRINTING SETTINGS

I used a .4mm nozzle, .2mm layer height, I use 10% infill No supports needed :-D It a fully print in place model! Make sure your printer is all set with a good calibration and retraction before printing it.


8 Likes3 DownloadsJuly 9, 2024


8 Likes3 DownloadsJuly 9, 2024
This model is restricted by licensing terms.