I'm test printing this later

I worked on this project for a bit earlier, and worked on the connections between the top and bottom. I worked out an easier way to align the hollow D20 in the middle, which was my biggest mistake in the first version.

I also resized it to half the size, the D20 is around 42mm. Still a heckin chonker!

I've set it up to print in place on the plate (I always mix that up) and Lychee says it will take 5 hours, 22 minutes.

I don't have any food safe PLA, but I'm not selling it and I can't sue myself if I poison myself, so I'm using this cool green PLA that turns yellow when it's heated, and when it's cooling it goes back to green. That should be pretty interesting to see as it changes temperatures.

Connecting top and bottom are my biggest worries. I hope they connect, but if they don't, I'm getting out the dremel. Or glue. Or both.