DT

Super Simple and Quick Test Pattern

by
rebeltaz
Follow
Follow
Remix Model
Super Simple and Quick Test Pattern 3d model
Super Simple and Quick Test Pattern 3d model
2D
3D
Makes
Be the first to upload a Make
This model is restricted by licensing terms. 

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:3915122.

I needed a super simple, super quick test pattern to test the z-offset on my BLTouch so I whipped this up in FreeCAD. All it is is a 150mm square bisected horizontally and vertically with one solid circle in each corner and one solid circle in the middle. The lines are all 0.8mm wide (2 perimeters with a standard 0.4mm nozzle); the corner circles are all 8mm in diameter; and the center circle is 16mm in diameter. Cura defaults to a 0.3mm layer height for the first layer, so that is the height of this pattern.

Printing at 0.2mm (essentially 0.3mm since it's only the first layer) with a print speed of 40mm.sec, this print only takes four minutes - not including the warm up time or time spent running a leveling profile.


NOTE Due to either a Thingiverse bug or (more likely) shadowbanning, my models no longer show up under the [Newest] listings. If you want to see more of my models, please be sure to 'follow' me. If you print this, it would really help if you'd post a 'make' so that others could find this model.


1 Likes18 DownloadsApril 26, 2022


1 Likes18 DownloadsApril 26, 2022
This model is restricted by licensing terms.