Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4802237.
Update (Mar 22, 2021): Version 2 is now live!
Changes in the version are as follows:
-
Rotated ventilation slots on the top of the Raspberry Pi case section to allow one of them to be used for passing through a camera ribbon cable to the connector on the Pi.
-
Enlarged the dovetail and slot while also deepening the angle of the sides of the dovetail to make it a true, non-directional friction fit.
-
Adjusted the cutout for the ethernet port on the end cap as it's currently a bit fiddly and easy to snap when installing.
-
Added a ramp for the SD Card slot to make sliding it into place easier.
Overview:
I liked dgeddings' model that this is remixed from, but like others in his comments was annoyed with the orientation of the Pi in the model. So I separated the Pi enclosure from the LCD shroud and added a dovetail (with stop) to make the entire process tool-less. Otherwise this is the same model as his.
One thing of note, I designed the dovetail to flip the Pi around in relation to the shroud but as this is a dovetail, friction should allow it to be installed in either direction.
Notes:
You need to print one of each file ending in _v2 to get the correct version.