Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4528768.

I liked the original ***Pergo KitchenAid Mixer Cover*** but could not fit it on my print bed no matter the orientation. So, I fixed that and made it available so others could benefit from it.

I have included the following unchanged files from the original Thing:

***Pergo_KitchenAid_Mixer_Lid.stl***
***Pergo_ConnectorFor_Small_Printers.STL*** [*print 2 of these*]

**UPDATE:** I removed the 2 piece version and created and uploaded a 3 piece version for even smaller printers.

KitchenAid Mixer Cover by Pergo for smaller printers

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4802237.

**Update** _(Mar 22, 2021)_**:** Version 2 is now live! 

Changes in the version are as follows:
1. Rotated ventilation slots on the top of the Raspberry Pi case section to allow one of them to be used for passing through a camera ribbon cable to the connector on the Pi.

2. Enlarged the dovetail and slot while also deepening the angle of the sides of the dovetail to make it a true, non-directional friction fit.

3. Adjusted the cutout for the ethernet port on the end cap as it's currently a bit fiddly and easy to snap when installing.

4. Added a ramp for the SD Card slot to make sliding it into place easier.

**Overview:**

I liked dgeddings' model that this is remixed from, but like others in his comments was annoyed with the orientation of the Pi in the model. So I separated the Pi enclosure from the LCD shroud and added a dovetail (with stop) to make the entire process tool-less. Otherwise this is the same model as his.

One thing of note, I designed the dovetail to flip the Pi around in relation to the shroud but as this is a dovetail, friction should allow it to be installed in either direction.

**Notes:**

You need to print one of each file ending in *_v2* to get the correct version.

Ender 5 Control Shroud with Pi (separated)

Model originally uploaded to Thingiverse at https://www.thingiverse.com/thing:4461246.

GPUs today come in one of 3 widths: single slot, double slot, and now 2.5 slots. The original thing has a 3 slot end plate that would hold any of these but I'm decidedly a minimalist so that just wouldn't do on something that hangs on the wall like a piece of art for everyone to see.

The current CPU in my system is of the two slot variety so I made this edit to the original. I will also be making a single slot variety as an update to this remix. After printing I have verified that the card fits snugly as intended and that even the thickest DisplayPort and HDMI cables I own fit past the slots and into their respective ports.

You will still need to print out all parts other than PCI_Slots.stl in the original from [lechukk](https://www.thingiverse.com/lechukk): https://www.thingiverse.com/thing:4391326

As this is to be wall mounted in a custom open air case it needs no connection to a backplane, as such. Therefore, I removed the mounting from from the top and smoothed the transition to the PCIE slot bracket for aesthetic reasons.


2 slot part for GPU Horizontal Support

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

ohmytallest

KitchenAid Mixer Cover by Pergo for smaller printers

Ender 5 Control Shroud with Pi (separated)

2 slot part for GPU Horizontal Support