Holds your credit cards.  Sides flex to hold cards securely.  Will fit 20 cards.  Loop for attaching keys.

Designed with FreeCAD.  Source FreeCAD file can be found here:  https://iammer.net/freecad/Card%20Holder-3.FCStd

Credit Card Holder - Wallet

Holds your credit cards.  

Designed with FreeCAD.  Source FreeCAD file can be found here:  https://iammer.net/Card%20Holder-3.FCStd

Credit Card Holder

End of the low pressure hose for Ryobi Inflator.

FreeCAD file available here:
https://iammer.net/freecad/Low-pressure%20hose%20end.FCStd

Ryobi Inflator Low Pressure Hose End

Bayonet to screw style adapter for low pressure air hose.  This was a replacement for my Ryobi 18V Dual Function Inflator.

FreeCAD source can be found here:
https://iammer.net/freecad/Low%20Pressure%20Hose%20adapter.FCStd


Ryobi Inflator Low Pressure Hose Adapter

Bayonet to screw style adapter for low pressure air hose.  This was a replacement for my Ryobi 18V Dual Function Inflator.

low-pressure hose adapter.stl

The hinge pins broke on my kids' Polly Pocket playset, so I designed and printed more.

There are 3 options when printing:

1. Print Vertically - has some strength issues. i.e pulling the pin out will almost certainly cause it to break.
2. Horizontally with supports - requires some post-print clean up.
3. Horizontally, but lower the print into the bed 0.4mm -- strong and no supports needed, but a little looser fit than otherwise.

Polly Pocket Hinge

Will hold a liquid until about a little more than half full then using a siphon mechanism will drain all liquid out the bottom.

https://en.wikipedia.org/wiki/Pythagorean_cup

Recommend scaling up for 3D printing (at least 1.5 times).

FreeCAD file available here:
https://iammer.net/freecad/Pythahoras_Cup.FCStd

Pythagoras Cup.stl

Minimal Ender 3 Pro Raspberry Pi Holder

Tried to come up with the simplest and fastest to print Raspberry Pi holder for the Ender 3 Pro. I used it for a Pi 3 B+ but should work with others. May also work for other 3d printers with similar extruded aluminum construction.

The pins holding the Pi are angled out slightly to allow it to be held securely. This will require some pressure to snap it in to place.

This can be attached anywhere using the T-slot. In my case I removed the display, slid it on, then reattached the display.

FreeCAD File is available here:
https://iammer.net/freecad/Minimal%20Ender%203%20Pi%20Holder%20v2.FCStd


Minimal Ender 3 Pi Holder v2

Minimal Ender 3 Pro Raspberry Pi Holder

Tried to come up with the simplest and fastest to print Raspberry Pi holder for the Ender 3 Pro. I used it for a Pi 3 B+ but should work with others. May also work for other 3d printers with similar extruded aluminum construction.

The pins holding the Pi are angled out slightly to allow it to be held securely. This will require some pressure to snap it in to place.

This can be attached anywhere using the T-slot. In my case I removed the display, slid it on, then reattached the display.

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like