Title says it all. This is a spool holder that clamps to the table so you can roll off thread as needed, as referenced in the photos. Simple, quick and easy. I used 40mm & 15mm hex bolts, but you can remix it based on whatever hardware you have available. I ran a 15mm bolt through the handle and into the top plate then bonded it with activator and superglue for good measure. I have included a version with an integrated thread channel for easy precise cutting of thread. Prints without supports in an upright orientation like in the image. The spool handle can be remixed based on the size spools you use.

Dry your filament, eat your vegetables, don’t do drugs.