Controller Tower

Don't have a 3D Printer? My models print great with These Printers (affiliate)

Controller Tower

This Controller Tower is print in place, with 4 controller mounts, and two slots for Nintendo Switch controllers. You can use it to store and display almost any controller or headset.

For those of you that want to know what I printed this with: I used marble PLA.

After you print it, the hinges should swing freely, and you'll need to break the smaller hinges free with some pressure. You may notice some stringing inside the smaller hinges, which can be removed with some snips.

I have also included a version that has the base attached (the All-in-one) version) so you can print the whole thing in one go. It's a little less fun because it doesn't have the thread, but it's a more economical print for print sellers.

Print information: The design has floating sections to allow the hinges to print in place. Make sure you print in the same orientation I used and you will be good to go!

Filament I used: Marble PLA