This tier gives you **unlimited access** to my full catalog! You will also have access to all my **new designs** as I post them. If you are an active member of this subscription tier, you also get commercial rights to **sell** these designs in your shop! Make sure to post your shop in the comments of my builds so I can share with my followers on socials!

**What you get with this tier**

1) Instant Access
As a new member you unlock instant access to the entire catalog

2) Commercial License
With active subscription, you have a commercial license to sell 3D prints from LucyTheMaker's Catalog.

3) Access to Future Designs
Active Members get free access to every new design released!

***

By signing up to the $10/month tier, you acknowledge and agree to all terms stated above. Any shop(s) or person(s) who break these terms of agreement will be held legally accountable

Full Access

A Cowboy Hat cover for your blistex tub. With a hole to make it into a keyring.

As blistex tubs vary slightly in size, for best results use a small piece of double sided tape on the base of each part before putting the tub in. This will give it the added friction needed while still allowing you to remove the tub when its empty!
If you have trouble removing the tub, heating up with a heat gun or hairdryer slightly should make it easier to get out! (Dont heat it up too much or it'll melt!)

Please leave pics of your prints below! 💖

My socials:
[Tiktok](https://www.tiktok.com/@lucythemaker)
[Youtube](https://www.youtube.com/@lucythemaker)
[Instagram](https://instagram.com/lucythemaker)

cowboy_hat_blistex_keyring.stl

Categories:

Tags: