This is a clip-on Apple AirTag holder so that your AirTag stays put inside your luggage, handbag, backpack or toolbag. Just snap in an AirTag then clip this onto a pocket or other edge to keep it where you can find it.

This is the XL model which holds the AirTag a little deeper wherever it is clipped. I also have a non-XL model available here… https://than.gs/m/1146485

100% printed - no hardware, fasteners, or adhesives required. No additional support is required.

This product was designed for a 0.4mm nozzle, a 0.2mm layer height and the following settings: Wall Line Count = 4 ( 4 x 0.4mm = 1.6mm walls ) Top and Bottom Layer Count = 5 ( 5 x 0.2mm = 1.0mm top and bottom ) Infill = 40%, Cubic Ironing = OFF (not needed) Support = None required Brim = NO (a brim can complicate details of print-in-place parts and parts printed close together) MATERIAL: PLA or PETG recommended (any material should work fine) PRINT ORIENTATION: On the side edge (as imported from STL)

See my blog for more details and other product info… https://www.logicalplanet.com/