Ducky Legs - Print in place #SpringThangs

Presenting Ducky Legs, the print in place duck model.

The model contains built in legs that extend and retract into the body. If leant back slightly when extended the legs will latch into position to keep the duck standing.

Eyes and beak need to be printed separately and glued into position.

Eye holes and beak hole need supports during printing.

#SpringThangs

KNOWN ISSUES: The beak was a little large for the hole in the head so I suggest scaling the beak part by 98% until I upload a replacement.

Depending on your infill settings, the weight of the model may make the duck tip backwards when standing but mine is just about fine with 10% infill. I'll look into moving the centre of gravity whilst in the standing position.