Two New Cat Food Can Tower Versions, Lid Holder

Finally felt confident enough to upload my revisions for the Cat Food Can Tower. Had to do some regluing a few times on the original, so worked on two different ways to make it stronger. Mark2 version is the one with slight improvements but should be able to print without much difference than the original, no new lifters needed. I also made a holder for the lids since they could get lost, it's based on the new version of tower.

I had another tower version I created (Big Boy), it was part of an exercise to experiment with learning a potential new program for my projects, Rhino3D. This one was done from the ground up and is a lot thicker in the walls, it's not exactly the same tower, so does have some variations. It does end up being weaker unless you make thicker walls or use solid infill in all or parts of the walls. It also needs a new lifter since the walls are thicker, the original ones just won't stick out enough to be as useful.

The connector piece still works on all three versions. The new lifter can be used in the original or Mark2 if you prefer a longer part sticking out for lifting/pulling.