tracking pixel
Daniel B

Diamond patterned cuffs - snap fastened

by
kaizen3dprints
Follow
Follow
Remix Model
kaizen3dprints
kaizen3dprints
|
|
Image 1 of 18
Diamond patterned cuffs - snap fastened 3d model
kaizen3dprints
kaizen3dprints
|
|
Image 1 of 18
Diamond patterned cuffs - snap fastened 3d model
2D
3D
Makes
Diamond patterned cuffs - snap fastened 3d model
Diamond patterned cuffs - snap fastened - Cuff over a sweatshirt - 3d model
Diamond patterned cuffs - snap fastened 3d model
Diamond patterned cuffs - snap fastened - two male snap fasteners oriented towards finished surface - 3d model
Diamond patterned cuffs - snap fastened - The backside of the two male snap fasteners - 3d model
Diamond patterned cuffs - snap fastened - The female snap fasteners directed towards the bottom of the cuff - 3d model
Diamond patterned cuffs - snap fastened - Here is the cuff snapped together - 3d model
Diamond patterned cuffs - snap fastened - Concentric bottom layer infill on Rippling PFLAT - 3d model
Diamond patterned cuffs - snap fastened - Rectilinear bottom layer infill on Rippling PFLAT - 3d model
Diamond patterned cuffs - snap fastened - Hilbert Curve bottom layer infill on Grafitti PFLAT - 3d model
Diamond patterned cuffs - snap fastened - Octagram Spiral bottom layer infill on Graffiti PFLAT - 3d model
Diamond patterned cuffs - snap fastened - Archimedean Chords bottom layer infill on Graffiti PFLAT - 3d model
Diamond patterned cuffs - snap fastened - Silk silver PLA example  - 3d model
Diamond patterned cuffs - snap fastened - 5 different sizes available - 3d model
Diamond patterned cuffs - snap fastened 3d model
Diamond patterned cuffs - snap fastened 3d model
Diamond patterned cuffs - snap fastened 3d model
Diamond patterned cuffs - snap fastened 3d model
This model is restricted by licensing terms. 

Included are 3mf with print settings, and individual STL files for a 3D printed wrist cuff. Additional materials required

These prints are .64mm tall. Print the first layer, add a pause command at the beginning of the second layer and add your mesh fabric on top of it, being held down by magnets (see photo). Resume your print and the printer will encapsulate the mesh between the 2nd and third layers. Remove the print from the build plate. Trim away the excess fabric along all edges. line up your male and female snap fasteners in the holes at either end of the cuff (see photo). You will put two male fasteners on one end (snap portion on the top surface of the print, and two female fasteners on the other side (snap portion on the bottom surface of the print). Voila! You can now wear this as a bracelet, or attach it to a sweatshirt cuff with a couple of snap fasteners. There are built in snap modules that will center the snap, as well as protect the fabric from the fasteners teeth.

There are 5 different sizes. Measure your wrist circumference and choose the correct one. The most common size is 195mm. If printed on a powermesh, there will be some stretch so you can size smaller. With a non stretch material, you will have to size accordingly.

In the example photos, I've shown what changing the bottom layer infill can accomplish when using the PFLAT build sheets. I used Concentric, rectilinear, archimedian chords, octagram spiral, and hilburt curve.


19 Likes45 DownloadsMay 16, 2024


19 Likes45 DownloadsMay 16, 2024
This model is restricted by licensing terms.