Upload for Search
Search By Text
Upload for Search
Search By Text
Juan R

Retract Test

by

juankmed

Follow
Follow
Like
Retract Test by juankmed full viewable 3d model
Loading preview...
22 Likes52 DownloadsMarch 25, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

22 Likes52 DownloadsMarch 25, 2022

Community Uploads

No photos added yet, be the first to upload a photo!

Print the part and check if you have some strings on your part. Si es asi, you could try to change the parameters to find the best settings to suppress this strings. The most important parameters you should check in your slicer to minimize the stringing are the following: Temperature Retraction distance Retraction speed Temperature is a vital factor and probably one of the 5 most important settings in your profile. If you have a lot of stringing you are almost certainly melting at too high a temperature. Remember that all materials have a range of temperatures in which they can be printed, so try lowering the temperature and bringing it closer to the lower limit recommended by the manufacturer. If you are already using a very low temperature and still have stringing, check the following points. While it is not possible to “suck” plastic out of the nozzle, as no negative pressure can be created, it is possible to minimize the pressure on the nozzle by pulling the filament out of the hot zone of our hotend. The shrinkage distance is very dependent on our printer, as both the melter and extruder and the type of extrusion (direct or bowden) must be considered. Most bowden printers perform well with a shrinkage value between 3mm and 6mm, and direct extrusion printers between 0.5mm and 2mm. The speed of retraction is another important factor, as the higher the speed the lower the stringing. This speed will depend on the motor of our extruder and also on the type of extrusion. Generally values between 40 mm/s and 60 mm/s usually work. Printing Conditions: - Nozzle Size : 0.4 - Layer Height : 0.2 - Initial Layer Height : 0.2 - Line Width : 0.4 - Wall Line Count : 3 - Top/Bottom Thickness : 0.8 mm - Enable Retraction : True Estimated printing Time = 7min
CategoryHobbies & Games




22 Likes52 DownloadsMarch 25, 2022

This model is restricted by licensing terms. 

Community Uploads

No photos added yet, be the first to upload a photo!

This model is restricted by licensing terms. 

22 Likes52 DownloadsMarch 25, 2022

Community Uploads

No photos added yet, be the first to upload a photo!