2D3D
Makes
This model is restricted by licensing terms.
View license.
23 Likes6 DownloadsMarch 2, 2024
This model is restricted by licensing terms.
View license.
This is one of my all time favourites- instead of a pendulum, this escapement uses a ball bearing rolling along a track to keep time. At the end of the track, the escapement hits a trigger which causes the track to slant the other way, starting the cycle again.
The video below shows how easily this mechanism can be assembled!
The STL File:
Prints on all standard 3d printers without supports, requires the following additional parts to assemble:
- 4 M4x12| 2 M4x20 Screws (https://amzn.to/3zgQb8f)
- 8 M4 Washers (https://amzn.to/3SApQsQ)
- 6 624Z 13mm OD/4mm ID Bearings (Like these https://amzn.to/3DtUUpH)
- 1mm Nylon String or Fishing Line (I used string from this set https://amzn.to/3DtUUpH)
- 7 Ball Bearings (https://amzn.to/3stFWKd)
Recommended print settings:
Layer Height: 0.2mm Nozzle: 0.4mm Infill: 15-18% Total Filament Required: ~200g Minimum Build Plate Required: 205x205mm
**All the files have been pre-oriented to save you some set up time! All you need to do is drop the parts into your slicer and hit print!
Categories:
23 Likes6 DownloadsMarch 2, 2024
This model is restricted by licensing terms.
View license.
23 Likes6 DownloadsMarch 2, 2024
This model is restricted by licensing terms.
View license.